JM744X, JM644X diaphragm type hydraulic and pneumatic quick mud valve is composed of a hydraulic or pneumatic source source for the implementation of the angle type truncated type valve mechanism is usually installed in a line in the bottom of the tank wall, used to rule out the bottom sediment of sand and dirt. The valve is made of nylon reinforced rubber diaphragm, which is divided into two chambers, connected with the hydraulic or pneumatic source, controlled by electric or manual four position two way reversing valve. The valve will replace the piston without movement friction, more suitable for mud and other granular media, greatly improve the life of the valve.
Note: parameters are for reference only, or are not full. Valve can be used in accordance with the requirements of different pressure, material, diameter, drive, etc.. Specific please contact or online

Part name	Month body, month cover	Diaphragm pressure plate, valve plate	The stem	diaphragm
Material Science	Cast iron, ductile iron, carbon steel	Ductile iron and bronze	Don't melt steel	Nylon reinforced rubber

1 nominal pressure: 0.6~1.0MPa
2 applicable medium: water, oil
3 minimum opening and closing action pressure: 0.2MPa
4 applicable temperature: 0 ~ 80
Note: if there are special requirements (indicate when ordering)

DN	100	150	200	250	300	350	400
L	160	190	225	260	280	315	340
L1	120	150	190	220	260	300	340
H	370	440	53	0615	785	880	970

No Information